CME BodyGuard 121 Twins, Operator'S Manual, Page: 55 / 81

55
5. Rate Screen
– Step 2
Pump displays the rate for step 2. Repeat the same
instructions for step 1 and repeat until the required number
of steps is entered.
6.
After entering the last required step, press without
entering a rate.
This indicates that all required data has been set. All
programs following the last set program will be automatically
cleared.

NOTE:
If pump is in Delay Mode , enter KVO rate.
7. Accumulation Screen
Do one of the following:

Press to confirm the existing parameters.

Press to go back to rate setting screen.

NOTE:
If pump is in Delay Mode , enter Start Time (24 Hour Clock) and Start Date. For further
information regarding the Delay Option, refer to Delay Program section.
8.
Press to Start Infusion.
9 During program operation, the display identifies which step
is currently running, as well as the rate.

NOTE:
If one of the values is changed during the programming mode, the pump will not recall
the new value unless changes are confirmed by pressing .
If prime procedure is activated during data setting, the pump will return to the original (previous)
screen once priming has completed.

NOTE:
Whenever required to stop infusion, press . Stop displays on the screen. Stop
mode is limited to two minutes. After two minutes an audible alarm sounds. Press again
to mute the alarm.

NOTE:
During programming you may backspace by using
Pressing once clears the last entered digit.
Pressing again clears the next number.
Pressing when the value is empty displays the original value or the previous screen.
Rate Step 1 of 5
25
ml/h
Start Infusion?
Steps Total 5
Volume Total 500 ml
Press OK to Start
Step 5 Rate
___ ml/h
Press OK for Volume
Step 2 Rate
___ ml/h
Press OK for Volume