WHEEL BRAKE ASSEMBLIES
Brake Shoe Installation
Page 6-8
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
6
Brake Shoe Installation, Continued:
7.2. Using 90° internal snap ring pliers (0.090 tip) (CCI P/N 1012560), attach the internal retaining ring
into the axle tube hub so that it seats against the axle bearing assembly and into the machined slot
in the inside wall of the axle tube hub
(Figure 6-3, Page 6-2)
.
7.3. Place a 1/4 to 3/8 - inch (6 - 10 mm) diameter rod against the retaining ring and tap lightly at four
or five locations to ensure it is properly seated.
See following WARNING
.
ý
WARNING
• Be sure retaining ring is properly seated in groove. If ring is not properly installed, the axle
assembly will separate from the transaxle and damage the axle assembly and other
components. Loss of vehicle control could result in severe personal injury or death.
ý
CAUTION
• Before installing axle shaft, clean any residual oil from the exposed end of the axle tube and
from the oil seal area.
8. Install the brake drum, and make sure that it is properly seated.
See following NOTE.
NOTE: If drum installation is difficult, the brake shoes may need to be adjusted vertically in the mounting
slots.
9. After the drum is installed, make sure the axle and drum turn freely and then install the wheel.
See Wheel
Installation, Section 8, Page 8-1.
10. Adjust brake cable equalizer.
See Brake Cable Equalizer Adjustment on page 6-9.
Figure 6-18 Equalizer Adjustment
EQUALIZER
TURNBUCKLE
JAM NUT
(1 OF 2)
