ACCELERATOR AND BRAKE PEDAL GROUP
Pedal Group
Page 5-6
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
5
PEDAL GROUP INSTALLATION
1. Place the MCOR on the pedal group and secure with two screws (1)
(Figure 5-3, Page 5-3)
. Tighten
screws to 23 in-lb (2.6 N·m).
2. Connect the wire harness (12) to the MCOR (11)
(Figure 5-2, Page 5-2)
.
NOTE: Connectors will only fit together in one orientation.
3. Position the pedal group in vehicle and secure with two screws (2) on the driver side and two screws (1)
on the passenger side. Tighten driver side screws (2) to 12 ft-lb (16.3 N·m). Tighten passenger side
screws (1) to 5 ft-lb (6.8 N·m).
4. Use the turnbuckle (6) to connect the rod from the pedal group to the brake actuator rod. Ensure the ends
of the brake cables do not slip out of the brake equalizer during this procedure.
5. Adjust the brake cable equalizer tension.
See Brake Cable Equalizer Adjustment, Section 6,
Page 6-9.
6. Place floor cover plate (7) over the floor opening
(Figure 5-2, Page 5-2)
.
7. Install the floor mat (2) over the pedal group. Make sure tabs on floor mat sides are beneath the sill (3).
Tighten screws (1) to 53 in-lb (6 N·m)
(Figure 5-1, Page 5-1)
.
Figure 5-5 Accelerator Spring Clip
Figure 5-6 Accelerator Spring Upper Crosspin
Figure 5-7 Accelerator Spring Pin Removal
1
