WHEEL BRAKE ASSEMBLIES
Brake Shoe Installation
2005 Precedent IQ System Electric Golf Car Maintenance and Service Manual
Page 6-7
6
4. While maintaining spring attachment on both shoes, position tips of leading shoe in the mounting slots
and then push shoe into place. Hold shoe in position and install retaining clip
(Figure 6-15, Page 6-7)
.
5. After the shoes are installed, move them together up and down and side to side to make sure that they
will easily slide approximately 1/4 to 3/8 inch (6.3 to 9.5 mm) without binding
(Figure 6-16, Page 6-7)
.
6. Place a flatblade screwdriver under the adjusting arm and raise the arm off of the adjusting wheel. While
holding the arm up, turn the wheel upward until it stops
(Figure 6-17, Page 6-7)
. Remove the screw-
driver.
7. Install the rear axle onto the transaxle.
See following NOTE.
NOTE: There is a LEFT and RIGHT side axle. The splined portions on the axles that insert into the tran-
saxle case are two different lengths. The longest length spline is the LEFT, or driver side axle.
7.1. Insert the splined end of the axle shaft into the axle tube. Be careful not to damage the seal on the
inside of the axle tube hub. Advance the shaft through to the bearing on the shaft, and rotate it to
align the shaft splines with the splined bore of the differential gear. Continue advancing the shaft
until the bearing on the axle is firmly seated within the axle tube hub seat.
Figure 6-15 Install Leading Shoe
Figure 6-16 Check Shoe Positions
Figure 6-17 Set Adjusting Wheel
LEADING SHOE
TRAILING
SHOE
FR
ONT OF
VEHICLE
B
A
ADJUSTING
WHEEL
ADJUSTING
ARM
