6
To install this system a (65 mm) (2.5") hole must be cut into the ceiling tile to allow
the large lower bezel just removed from the packaging to be fixed to the tile. The
hole should ideally be cut in the centre of the tile and must not be closer than
(76mm) (3") from the edge of the tile or it will not be possible to align the CCRM
4000 support bracket over the hole.
Take the entire CCRM 4000 kit up to the final location site. Carefully align the
CCRM 4000 complete with ceiling tile bracket so that the large slot is directly
over the hole that has previously been cut in the ceiling for the bezel. Make
sure that the front and back of the bracke
t fits snugly over the ceiling tile “T-
Bar rails”. Secure the ceiling bracket to the T Bar rails using the four eye bolts
finger tight.
(65mm) 2.5" Hole
Insert the bottom part of the bezel up through the ceiling tile through the hole
and slot in the tile bracket. Secure the bezel in place with the securing ring.
