17
Point the remote at the IR Sensor press 01 followed by the ENTER button (green
programme led on the IR sensor will light). Press the Up / Down buttons on the
remote set the correct height of the microphone, press the ENTER button to store
the desired height in the memory (green led will extinguish).
Immediately afterwards the microphone will retract to the ceiling bezel to confirm that
the operation has been successful.
Briefly press the Down button and the microphone will move down and stop at the
programmed height. Press the up button and the microphone will retract
back up to
the Bezel. If an incorrect height has been programmed then repeat the above
instructions
Programming multiple units
As each additional slave units is added it will be necessary on each of the slaves to
change the
“units”
decim
al rotary address switch to “2” for the 2
nd
slave / “3” on the
3
rd
slave etc… then as described above repeat the button sequences on the remote
to set each of the cable heights on each of the slaves in turn. Don’t forget to enter
the slaves assigned number on the remote (02 or 03, 04 etc) before completing the
programming sequence. If 10 or more Retractas are being used then it will be
necessary to change the
Tens
rotary address on the 10
th
slave to “1” and Units
rotary switch to “0” (10), for the 11
th
slave select “11” and so on. If you have now
completed the installation of several Retractas you can now check that all cables are
deployed simply by pressing the down button
