14
IR Remote control operation
The remote is primarily intended to allow the initial programming of the desired
height for each individual winch in the system. The preferred operation is then by
logic input from a DSP logic high of 2.5V to 12V is required to release microphone to
programmed height and a logic 0 low will raise the microphone. The IR remote
Up/Down buttons can be used if a DSP is not used. Open the battery compartment
pull and remove the battery insulator / protector.
IR Remote Layout
Aux: Used to programme the remote.
Up: Used to rewind cable upwards
Down: Used to deploy cable downwards.
Enter: Used to complete / store a programme.
Setup: Only used to programme the remote.
Numeric buttons: Used to input Master / slave
designation and programme remote.
The red LED indicator shows with each press of any button. If the LED fails to light
then replace the battery
Replacement battery type Lithium 3V CR2025
WARNING: DANGER OF EXPLOSION DO NOT BURN OR INCINERATE THE
BATTERY.
Warning
:
Do not use both the IR Remote control and DSP together it will not
work. The microphones must be at the ceiling bezel then use the remote or DSP
to operate the unit
.
Remote code 0515
When the battery is replaced it
may be necessary to re code the
remote. Press Aux, Press and
hold Setup until red led lights,
enter 0515 on the key pad.
Remote coding is now set.
