Climax VM1350, Operating Manual

Page: 45 / 98

P/N 89800, Rev. 2 Page 33
4 OPERATION
IN THIS CHAPTER:
4.1 P
RE
-
OPERATION CHECKS
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 33
4.2 E
LECTRIC DRIVE MOTOR
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 35
4.3 P
NEUMATIC DRIVE MOTOR
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 37
4.4 C
HANGE OF ABRASIVES
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 38
4.5 C
HANGE OF DRIVE MOTOR
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 39
4.5.1 C
HANGE OF MOUNTED DRIVE MOTOR
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - 39
4.5.2 M
OUNTING OF NEW DRIVE MOTOR
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 40
4.1 P
RE
-
OPERATION CHECKS
Do the following checks before operating the machine:
1. Complete the risk assessment checklist in Table 1-3 on page 5.
2. Check that the work area is clear of non-essential personnel and equipment.
3. Check that the machine control/observation area will not be in the path of
hot flying chips during machine operation.
4. Check the machine is securely mounted to the workpiece.
5. Check that air hoses are routed and secured to avoid tripping, entangle-
ment, damage from hot chips, or other damage should an air hose or con-
nection fail.
6. Check the tool condition and sharpness.
7. On the PCU, check that the oil drip rate is set to 6 drips per minute.
8. Check all hand tools are removed from inside the machine and the work
area.
CAUTION
Do not reach with hands or other sections of the body into
rotating tools. Wear eye protection glasses during grinding and
lapping operation.