Clenergy Australia
| 1/10 Duerdin St, Clayton VIC 3168 | T: +61 3 9239 8088 | [email protected]
Page 12 of 18
Double support installation
Place the double support (pre-
assembled) into post head. Connect
the tubes of the support the to the
post braces on the post using the
M12 bolt and nut supplied
Recommended torque:
55 Nm
Note: The lengths of the two tubes
are different. Make sure the shorter
one is positioned at the lover part of
the tilt as shown.
②
．
Connect the shorter Tube
Support to post brace.
③
. Adjust the bolt position of T
head in order to prevent the hole of
the post brace can’t align to the hole
of Tube Support
④
. Rotation the orientation of T
head to in order to prevent the Tube
Support can’t fit the post brace quite
well.
