FUNCTIONING
GIAMPY
Rev. 00
15/02/2012
Pag. 28/43
.7.4 RUDDER PEDALS FUNCTIONS
This machine is equipped with different levers and pedals:
traction drive lever (part 1 Figure 4.9). The machine has a red switch for forward and reverse lid
placed on top of the handle, before you pull the lever to pay attention to the positioning of the switch.
The lifting brush lever activates all the moving parts of the machine. When switched on, with
the on board operator, brushes start to move and the suction motor activated by the control
bridge.
Lifting up squeegee lever (particular 2 picture 4.9). Pulling up this one and putting it to its place is
possible to control the squeegee.
Water floating regulation (particular 3 picture 4.9). Pulling up or down the lever to get a good
regulation of the water.
lifting pedal flat brushes (particular 4 Figure 4.9). To raise the pot off the ground press the pedal until
it clicks into place at the headquarters of the plate, to lower it back, press the pedal and release it
from the plate.
brake lever (particular 5 Figure 4.9). Pulling the lever toward you if the car brakes, dropping the
machine will be able to 'move freely.
parking brake (part 6 Figure 4.9). pulling the small lever towards you in red along with the brake
lever applies the brake. To remove it do a little pressure on the red lever.
2
1
3
PICTURE N° 4.9
4
5
6
