INSTRUCTIONS FOR STARTING AND USE
GIAMPY
Rev. 00
15/02/2012
Pag. 22/43
4.5. INSTALLATION
The installation must be done by authorized personnel after reading this manual.
4.5.1 BATTERIES INSTALLATION
To install the batteries follow the instructions as below :
Raise up the battery-cover chain guard (picture 4.4);
install the batteries in the suitable slot as showed in picture 4.4 being sure that no breakings are in
the battery cases;
never add distilled water after charging the batteries;
clean up the surfaces needing to be connected ;
Battery handling is made easier by handles on both sides.
4.5.2 CHARGER INSTALLATION
The battery charging must be done, as previously reminded, predisposing a suitable suction system of gases
coming out during charging. Alternatively it must be done in a dry and airy place, far from heat sources and
corrosive environments.
Protect the electrical system with a delayed switch or with a more capacity fuse than the charger.
Follow the polarity instructions for the battery inlet.
This machine is equipped with a charger placed inside the battery cover, therefore to charge the batteries
follow the instructions and connect directly the cable to the system.
PICTURE N° 4.4
Verify that the battery plug is connected
PICTURE N° 4.5
Locking lever for recovery tank
