16
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CARE DURING USE
1. DO NOT allow the pump to run dry, otherwise the seal between the pump
and motor may be damaged. If a leak occurs at this point, allowing water
to pass from the pump to the motor, take the pump to your Clarke dealer
for overhaul.
2. In the event of a blockage, where debris has entered the suction
chamber, it can be cleaned out as described under MAINTENANCE.
3. Should contaminants come into contact with the pump, flush through with
cold water as soon as possible to prevent damage. DO NOT USE for
pumping chemicals or other corrosive liquids (other than pool purification
chemicals in their correct mix ratio).
4. If the pump is being used to drain a pool or pond, ensure there is adequate
drainage and there is no risk of damage to property as a result of water
being discharged. If a flexible hose must be laid across a roadway, protect
it with wooden planking.
AFTER USE
If the pump will not be used over the winter period, or whenever there is
danger of freezing, always drain the pump body. If the pump has been used
with contaminated or salty water, it should be thoroughly flushed with clean
water following use, both inside and out. It should then be drained and
covered over, if not already installed in a clean, dry environment sheltered
from the weather. In the event that dismantling and overhaul of the pump is
necessary, contact your CLARKE service department.
Summary of Contents for EBP1100
Page 24: ......