9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
BEFORE USE
INVENTORY
When unpacking, check to ensure that all the parts listed are present. If any are
missing or damaged, contact your CLARKE dealer.
• 1 x Grinder
• 1 x Stone Grinding Wheel
• 1 x Water Tank
• 1 x Tool Support
• 1 x Tin Abrasive Paste
• 1 x Angle Guide
• 3 x Tool Holders (small knives, large knives & straight edges)
FITTING THE TOOL SUPPORT
1. Stand the grinder on a flat and
sturdy benchtop.
2. Insert the tool support into the
two mounting holes at the top of
the wet grinder as in Fig 1.
Vertical Grinding/Honing
3. Adjust the tool support to the
desired height, before tightening
the two knobs to secure it in
place.
Horizontal Grinding
4. Attach the tool support by
inserting into the two mounting
holes located on the rear side of
the grinder. Adjust to the desired
height, before tightening the two
knobs to secure it as in Fig 2.
5. Plug the machine into the nearest
power supply.
