14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
MAINTENANCE
INSTALLING A NEW GRINDING STONE
1. Unscrew and remove the nut, and
washer that secures the stone in
place.
2. Remove the old grinding stone
and install the replacement,
securing it with the nut and
washer. Grasp the honing wheel to
prevent the drive shaft from
turning while tightening the nut.
DRESSING A NEW STONE
New grinding stones are frequently not true and in time can become
grooved, glazed (built-up), out of round or otherwise mis-shapen. To correct
these defects, a grinding stone dresser is required. This is available from your
Clarke dealer.
ET125 Grinding Wheel Dressser,- Part No: 1700225
Replacement Dresser Wheel,- Part No: 1700230
ET154 1/2 Carat Diamond Tip Wheel Dresser,- part No:1700329
1. If the grinding stone is new, allow it to spin for a minute with no load. Check
that it is spinning straight and true. If not, it will require dressing before use.
2. Stand to the side of the grinding stone and hold the dresser handle firmly.
Place the dresser on the tool support so that its wheels can move freely
(i.e, the exposed part of the wheel should be facing up). Run the grinding
stone at full speed and apply the dresser to the surface of the grindstone.
INSTALLING A NEW HONING WHEEL
1. Unscrew and remove the nut and
washer that secures the wheel in
place.
2. Remove the old honing wheel and
install the replacement, securing it
with the nut and washer. Ensure
the drive pin, rests in the groove in
the hidden face of the wheel.
