11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING YOUR GRINDER
GETTING STARTED
1. Slide the support plate onto the
tool support. Position the support
plate directly above the grinding
stone or honing wheel. Loosen the
two knobs, on the support plate.
Insert the tool blade (sharp end
downwards) in the support plate,
then firmly tighten the tool blade
in place as in Fig 6.
2. Adjust the tool support so that the
support plate is approximately 1-
2mm from the grinding stone or honing wheel. Loosen the two knobs on the
support plate to adjust the tool blade so that its sharp edge lightly touches
the grinding stone or honing wheel.
3. Turn on the grinder and slowly move the support plate back and forth
along the tool support to grind the tool blade. If necessary, loosen the two
knobs on the support plate to re-adjust the tool blade.
WARNING: FRAGMENTS FROM A BROKEN/DETACHED GRINDING WHEEL
CAN CAUSE SERIOUS INJURY.
WARNING: WHEN USING THE GRINDING WHEEL, DO NOT STAND DIRECTLY
IN LINE WITH THE ROTATING WHEEL.
WARNING: ENSURE THAT THE WORKING POSITION ADOPTED DOES NOT
CAUSE OPERATOR FATIGUE WHICH MAY LEAD TO LOSS OF CONTROL OF
THE TOOL BEING GROUND.
WARNING: WHEN GRINDING, KEEP THE TOOL BLADE STRAIGHT TO
PREVENT SNATCHING OR JAMMING.
WARNING: THE STONE WILL CONTINUE TO ROTATE FOR A FEW SECONDS
AFTER THE SWITCH HAS BEEN PRESSED.
