18
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
STORAGE
1. Follow the shutting down procedure on page 14.
2. Disconnect the high pressure hose and drain all water from the hose.
3. Coil the hose and store the gun/lance in the holders located on the side
frame of the pressure washer.
STORAGE PROCEDURE
Make sure that the pressure washer has been thoroughly cleaned before
storing it in a clean dry place. For long term storage See page 20.
MAINTENANCE
CLEANING THE NOZZLE
1. Switch off the pressure washer and the water supply.
2. Pull the trigger to release any water pressure.
3. Disconnect the lance from the gun assembly.
4. Remove all blockages with the
nozzle cleaning tool provided and
back flush with clean water.
5. Run water into the end of the
lance for 30 seconds to back flush
loose particles.
6. Reconnect the lance to the gun
assembly and turn on the water
supply.
CLEANING THE WATER INLET FILTER
1. Remove the filter from the water
inlet of the pump as shown.
2. Clean the filter by flushing both
sides with water.
3. Replace the filter into the water
inlet.
• Do not operate without the filter properly installed.
Summary of Contents for 7320202
Page 28: ......
