14
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Other ways to adjust the pressure include. Changing the distance you are
from the surface being cleaned and adjusting the spray to a wider angle
(lowers the pressure).
APPLYING CHEMICALS AND CLEANING AGENTS
To improve the cleaning performance, You can introduce chemical cleaning
agents (detergents) to the water jet using the detergent pickup hose.
1. Place the detergent pickup hose into a container holding the chemical/
cleaning solution.
• Only use detergents recommended for use with pressure washers,
such as CLARKE Traffic Film Remover which is a powerful low
foaming agent for car cleaning, patio cleaning etc., or CLARKE
Wash & Wax, both available from your CLARKE dealer.
2. Hold the rear of the nozzle and slide the front of the nozzle forwards to low
pressure.
3. Spray the detergent onto the vehicle, patio etc.
• Allow the detergent a little time to work itself into the grime.
4. To rinse, remove the detergent pickup hose from the container holding
chemical/cleaning solution and use the pressure washer as normal.
SHUTTING DOWN
1. After each use, if you have applied chemicals, place the detergent pickup
hose into a container of clean water and run clean water through the
detergent pickup hose to flush the system thoroughly.
NOTE:
Failure to do so could cause damage to the pump.
2. Move the throttle control lever to
the right.
3. Turn off the engine switch.
NOTE:
NEVER turn the water off with
the engine running.
CAUTION: IF YOUR EYES COME INTO CONTACT WITH ANY CLEANING
FLUIDS, RINSE THEM IMMEDIATELY WITH PLENTY OF FRESH CLEAN WATER.
AND SEEK MEDICAL ADVICE IF REQUIRED.
Summary of Contents for 7320202
Page 28: ......
