8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
7. Fit the angle adjusting plate to the
bearing housing opposite the
drive spindle end. Slide it over the
cradle spindle and bolt it to the
bearing housing with two M8 x
25mm bolts. (
Fixing pack G)
.
8. Insert the return spring into the
sleeve on the tilt handwheel and
slide the handwheel onto the
cradle spindle. Insert the M10 x 70
securing bolt through the wheel
and through the cradle spindle
before securing with two M10
nuts. (
Fixing pack H
)
9. Adjust the tensioning bolt shown
to set the spring tension to allow a
steady movement when
engaging the wheel with the cradle.
10. Take the motor/drive assembly
and insert the drive spindle
through the drive pulley,
positioning the drive assembly
against the main frame.
NOTE:
The drive spindle has a flat
side to correspond with the
flat provided in the drive
pulley. Rotate the lower
drum gently to turn the
spindle and align the flats.
11. Take the drive assembly with the
cover hanging loose from the
cable. Slide the large driven
pulley onto the drive shaft
complete with drive belt.
12. Bolt the drive assembly to the
main frame using four M8 x 25 mm
bolts/nuts/washers.(
Fixing pack I
).
• Bolting the drive to the frame
will tension the drive belt.
Summary of Contents for 3400841
Page 16: ......
