11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CARE AND MAINTENANCE
BEFORE STARTING WORK
Inspect the power cable and ensure it is free from damage and is not in
danger of being damaged by vehicles, equipment or other operations taking
place on the work site.
AFTER USE
At the end of the working shift it is essential that the machine is hosed down
thoroughly with clean water, being sure to remove all traces of the cement
mix especially from around the mixing blades. The drum may be scoured for a
couple of minutes running using course gravel and water which is then
discharged and the drum finally hosed clean.
Never allow cement residue to harden inside the drum and thereafter be
tempted to beat on the drum with hand tools to dislodge such accumulations
of dried cement.
The machine is constructed to IP44D ingress protection which enables the
drum and any other areas to be hosed down safety.
STORAGE
The mixer can be better stored with
the axle frame and support stand
folded away.
Remove the top bolts only from the
axle frame and support stand and
lower the mixer to the floor with the
help of an assistant. Loosely re-fit the
bolts and nuts into their respective
holes for safe keeping.
Leave the mixer with the drum
inverted to exclude water or debris and always store the mixer in a dry place
out of reach of children.
PERIODICALLY
After extensive use, inspect the paintwork and remove any rust that may be
apparent before touching up where necessary with a rust resistant paint.
CAUTION: OWING TO THE WEIGHT AND BULK OF THE MIXER, TWO
PEOPLE WILL BE REQUIRED TO LOWER THE MIXER AND RE-FIT THE BOLTS.
Summary of Contents for 3400841
Page 16: ......
