WS1”, 1.5” & 2” Series Watersoftener
Installation Operation Maintenance Manual
SIMPWS1 REV3 13/07/11 PAGE 16 OF27
9.3 NO REGENERATION
Check electrical supply, fuses etc. satisfactory.
Check control head motor runs by initiating a manual regeneration
(Press “REGEN” button for 5s and then again for a further 5s), listening
for drive motor ‘whirring' as it advances between cycles. Replace if
necessary.
Check internal meter running freely (if fitted) indicated by small black
dot in center of display flashing.
9.4 UNSATISFACTORY CAPACITY BETWEEN
REGENERATIONS
Check condition of resin. It may have become fouled, inhibiting the
regeneration process. If fouled, it should be cleaned or replaced.
Check incoming water for presence of Chlorine. If high, the resin may
have been degraded.
Check raw water pressure. Too high pressure may mean the brine
draw stage of regeneration is not effective
10.0 WARRANTY AND SERVICE
10.1 AFTER SALE WARRANTY
Your softener is covered by a parts warranty for a period of one year
from installation or 14 months from purchase.
Should you have any problems with your softener or require a routine
service, please contact your supplier.
