Claas TUCANO 500, Information And Basic Field Settings

Page: 30 / 48

30
Settings: Cutterbar Adjustments
Check the height of the auger within the
trough of the cutterbar. There should be
a minimum gap of 20mm between the
trough and the auger flights.
Check the height:
Remove the intermediate retractable
fingers along the length of the auger
leaving just the middle ones.
Retractable fingers:
In exceptional wrapping conditions, the
speed of the auger can be slowed by
optional sprockets on the chain drive shaft.
With the split reel cutterbar, two sets of
sprockets are required.
Sprockets:
Lift the skids as high as possible to get as
much movement for the sensor bands.
The skids underneath the cutterbar should
be set to suit the local conditions.
Lift the skids: