Claas LEXION 740, Information And Basic Field Settings

Page: 56 / 60

Frequent Questions
Threshing won’t engage and none of the hydraulics are working.
Check that the road travel switch is not engaged.
Threshing has engaged but the engine will not go to full rpm when
the engine speed dial is turned.
Check that the combine is not in 3rd gear.
Getting a poor sample in Oilseed Rape.
Check that the preparation floor is clean.
The machine will not change gear.
Make sure that the multifunction lever is in its neutral position and both
the footbrake pedals are applied, then briefly press the gear rocker switch
once to select a gear.
The machine goes off course when AUTOPILOT is engaged.
Make sure that the LASER PILOT is set up correctly.
The machine is lacking performance.
What are the settings in CEBIS, what are the crop and field conditions.
Make sure that threshing segment is removed from the main concave and
that the crop is not being over threshed.
When chopping check that the fine chop step is not engaged and the
stationary knives are backed off.
CRUISE PILOT or CEMOS will not engage
Make sure the cutterbar in work and the cutterbar is below the working
position.
56