Claas LEXION 740, Information And Basic Field Settings

Page: 30 / 60

30
Settings:
Cutterbar Adjustments
TIP. Check the height of the auger within the trough of the cutterbar. There
should be a minimum gap of 20mm between the trough and the auger
flights.
TIP. Remove the intermediate retractable fingers along the length of the
auger leaving just the middle ones.
TIP. In exceptional wrapping conditions, the speed of the auger can be
slowed by optional sprockets on the chain drive shaft. With the split reel
cutterbar, two sets of sprockets are required.
The skids underneath the cutterbar should be set to suit the local conditions.
TIP. Lift the skids as
high as possible to get
as much movement for
the sensor bands.