________________________________________________________ 53
Chapter 3: Paper Handling
_________________________________________________________________
5. Press the PARK/LOAD
▲
key to adjust the paper upwards in
1/72-inch increments. Or, you can press the LF/FF
▼
key to
adjust the paper downwards in 1/72-inch increments.
You can adjust the top-of-form from
–60/72-
inch to
+144/72-
inch.
6. Save your new top-of-form as the default setting by pressing the
QUIET/SAVE key for about two seconds.
If you want to print on the first line on the paper, set variable top-
of-form to
–60/72-inch
.
If you want your new variable top-of-form to be only a temporary
setting, do not press the QUIET/SAVE key. Simply press ON LINE.
If you do not save it, the new variable top-of-form setting is
discarded as soon as the printer is turned off
.
You can set one variable top-of-form for single sheets and another
for continuous paper and save both settings in one macro. The
GSX-190 senses which variable top-of-form to use by the position of
the paper select lever. This convenience eliminates the need to
change the top-of-form each time you switch between continuous
paper and single sheets.
When variable top-of-form is set between -24 and -60:
* Print quality in the top
6/7
inch of the page may not be as good
as the rest of the page.
* Occasional paper feeding problems may occur.
* Do not print in the first or last 1 inch {10 characters at 10 cpi}
of the first two lines of the page as shown in Figure 3-14.