________________________________________________________ 43
Chapter 3: Paper Handling
_______________________________________________________________________
You must be printing on continuous paper with the tractor unit in the push
position to use this feature.
When your computer indicates the end of a print job {by sending
a form feed command and no further data}, the GSX-190
automatically advances the continuous paper so the perforation
is at the tear bar. To remove the paper, just pull it across the tear
bar. The printer automatically retracts to the correct top-of-form
{starting position} when your computer starts the next print job.
Sometimes a print job will end in the middle of a page. To
advance the paper to the tear-off-position, press the ON LINE
key to take the printer off line, and then hold the LF/FF key for 2
to 3 seconds.
If the paper you are using does not advance to the perforation,
check the length of the paper against the form length setting on
your printer.
Figure 3-9. Using the tear bar.
