Cisco WAP571, Administration Manual

Page: 18 / 192

Status and Statistics
System Summary
Cisco WAP571/E Administration Guide 18
2
System Summary
The System Summary page shows basic information such as the hardware model
description, software version, and the time that has elapsed since the last reboot.
To view system information, select Status and Statistics > System Summary . You
can also select System Summary under Device Status on the Getting Started
page.
The System Summary page shows this information:
• PID VID —The WAP hardware model and version.
• Serial Number —The serial number of the Cisco WAP device.
• Base MAC Address —The WAP MAC address.
• Firmware Version (Active Image) —The firmware version number of the
active image.
• Firmware MD5 Checksum (Active Image) —The checksum for the active
image.
• Firmware Version (Non-active) —The firmware version number of the
backup image.
• Firmware MD5 Checksum (Non-active) —The checksum for the backup
image.
• Host Name —A name assigned to the device.
• System Uptime —The time that has elapsed since the last reboot.
• System Time —The current system time.
• Power Source —The system is receiving power-over-Ethernet from PoE
power-sourcing equipment (PSE).
The TCP/UDP Service table shows basic information about protocols and
services operating on the WAP.
• Service —The name of the service, if available.
• Protocol —The underlying transport protocol that the service uses (TCP or
UDP).
• Local IP Address —The IP address, if any, of a remote device that is
connected to this service on the WAP device. All indicates that any IP
address on the device can use this service.