Step 3
Holding the compute node vertical, align it with the empty module bay in the chassis.
The compute node is correctly aligned when the compute node top cover is pointing to the left.
Figure 6: Aligning and Installing a Compute Node
Step 4
When the compute node is almost completely installed, grasp the ejector handles and arc them toward each other.
This step seats the compute node into the connector. The compute node should power up.
Step 5
Push the ejectors until they are parallel with the face of the compute node.
When the compute node is completely installed, the retention latches at the end of each handle click into place.
Step 6
Configure the compute node as needed through Cisco Intersight.
See
Compute Node Configuration, on page 14
Compute Node Configuration
Cisco UCS M6 compute nodes, such as the Cisco UCS X210c M6, can be configured and managed using the
Cisco Intersight management platform in Intersight Managed Mode (Cisco Intersight Managed Mode). For
details, see the
Cisco Intersight Managed Mode Configuration Guide
, which is available at the following
URL:
Cisco Intersight Managed Mode Configuration Guide
Cisco UCS X210c M6 Compute Node Installation and Service Note
14
Installing a Compute Node
Compute Node Configuration
