Cisco TelePresence 3000, Installing And Removing

Page: 11 / 58

11 OL-23393-01
Step 4
Pull the speaker board out approximately six inches (15 cm).
Step 5 Loosen the screws that attach the spade terminals and speaker cable to the speakers, then remove the
cables from the speaker.
Step 6
Remove the speaker board.
Step 7 Repeat Step 3 through Step 7 to remove the center and right speaker boards and speakers.
Step 8
Remove all speaker board brackets and either the screen clips or locating plate for the screen.
The top illustration in Figure 5 shows the speaker board brackets. The lower illustration shows the clip
and the locating plate; remove either the clip or the plate, depending on your system.
Note Make a note of the hole location for the clips or plates; you use these same holes to install the new plates
in
Step 4 of the “Attaching the Screen and Shelf Attachment Hardware and Display Frame Brackets”
section on page 12 .
Figure 5 Speaker Board Bracket
206945