15
Cisco Smart+Connected Portable Tablet Reference Guide
OL-27364-01
Power and Battery Management
Composer Pro Configuration
Using Composer Pro, add the driver for the Cisco Portable Tablet to your project.
Procedure
Step 1
Start Composer Pro and connect to a Director (Cisco Controller running on the network).
Step 2
Add the Cisco Portable Tablet driver to the project:
a.
In the
System Design View
(default view) project tree (left pane), highlight the room where the
Cisco Portable Tablet resides.
b.
Under
My Drivers
, double-click
Portable 7” Touch Screen V2
.
Step 3
Identify the device:
a.
Click the
Connections
>
Network
tab.
b.
In the
IP Network Connections
list (center pane), highlight
Portable 7” Touch Screen V2
, and then
click
Identify
.
c.
When prompted, go to the Cisco Portable Tablet and press the bottom button on the right side, as
indicated on the
Identify
screen in Composer Pro, to identify the device to the network.
d.
When the address displays in Composer Pro, click
Close
.
Tip
See the
Cisco Smart+Connected Residential Installation and Configuration Guide
for more
information.
Power and Battery Management
Note
A lithium ion polymer rechargeable battery is used in this product. The battery in this product is non-user
replaceable and should be removed by a Cisco authorized service technician only.
•
Battery Instructions, page 15
•
Power Off the Device, page 16
•
Power Management Best Practices, page 16
Battery Instructions
•
For safety reasons, the battery is shipped only partially charged. When you are ready to use the Cisco
Portable Tablet, fully charge the battery by placing it in the docking station for at least four (4) hours.
•
If you remove the Cisco Portable Tablet from the docking station for long periods of time, the
touchscreen turns off. In this case, insert the Cisco Portable Tablet into the docking station again to
recharge the device. A Red or Orange LED indicates that it’s charging. See the
“LED Indicators”
section on page 4
for more information.