![background image](http://html.mh-extra.com/html/cisco/rf-gateway-10/rf-gateway-10_release-notes_64978044.webp)
44
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
OL-18677-10
Caveats
Open Caveats for Cisco IOS Release 12.2(50)SQ1
There are no open caveats in Cisco IOS Release 12.2(50)SQ1.
Resolved Caveats for Cisco IOS Releases 12.2(50)SQ1
CSCtk08497
Symptoms: The secondary line card becomes active after image upgrade.
Conditions: This issue occurs when the Cisco RFGW-DS48-1G is the secondary
line card and the Cisco RFGW-10 DS-48 is the primary line card after image
upgrade.
Workaround: Manually switch over the primary and secondary line cards.
CSCtk14770
Symptoms: The qam-red interface reverts back to its start-up configuration state
(shut or unshut) after Supervisor switchover.
Conditions: This issue occurs when line card redundancy is configured,
Supervisor is in stateful switchover (SSO) mode and the qam-red interface is
unshut when in "shut" state or shut when in "unshut" state before Supervisor SSO
happens.
Workaround: Manually unshut the qam-red interfaces in "shut" state or vice versa.
Caveat
Description
Caveat
Description
CSCtf46739
Symptoms: The
default service heartbeat
configuration command does not set the
heartbeat timers of the warning-timeout, fatal-timeout, and alive-timeout to their
respective default values of 3 sec, 5 sec, and 300 sec.
Conditions: This issue occurs while executing the
default service heartbeat
configuration command.
Workaround: Set the three timers individually as follows:
Router(config)#
service heartbeat warning-timeout 3
Router(config)#
service heartbeat fatal-timeout 5
Router(config)#
service heartbeat alive-timeout 300
CSCte87050,
CSCtf91969
Symptoms: A multiple program transport stream (MPTS) pass-through session
generates input overruns, and the output drops the alarms.
Conditions: This issue occurs when the input MPTS session contains one or more
programs with bad Program Clock References (PCRs). The set-top box is unable to
lock and display the programs in the output QAM channel.
Workaround: There is no workaround.
CSCtg00973
Symptoms: The Cisco RFGW-10 Supervisor card cannot boot up.
Conditions: This issue occurs when the
clear config all
command is executed. This
command resets the environment variables on the Supervisor card including the
“SkipDiagsAlways” variable, which on power cycle triggers a boot up diagnostic.
Boot up diagnostics is not supported on the Cisco RFGW-10 Supervisor card,
which causes the Supervisor card to hang during boot up.
Workaround: Set the “SkipDiagsAlways=1” in ROMMON mode.