![background image](http://html.mh-extra.com/html/cisco/rf-gateway-10/rf-gateway-10_release-notes_64978030.webp)
30
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
OL-18677-10
Caveats
CSCud16912
Symptoms: The compact flash statistics display incorrectly on standby Supervisor
card.
Conditions: This issue occurs after swapping the compact flashes between the
active and standby Supervisor cards.
Workaround: There is no workaround.
CSCud19522
Symptoms: The standby Supervisor card goes to Route Processor Redundancy
(RPR) mode after a switchover.
Conditions: This issue occurs when line cards are removed from a redundancy
group in a line card redundancy configuration, and
redundancy force switchover
command is issued on the Cisco RFGW-10 router.
Workaround: There is no workaround.
CSCud25340
Symptoms: The following error message is observed on the Cisco RFGW-10
router. DEPI sessions cannot be established.
.Nov 16 17:24:58.434: %NETWORK_RF_API-6-IDB_TRANSITIONS_PENDING:
Switchover terminated with 78 transitions pending after there was no
transition activity for 30 seconds
Conditions: This issue occurs after a Supervisor switchover.
Workaround: There is no workaround.
CSCud38024
Symptoms: DEPI sessions in other QAM interfaces also get deleted when
default
interface range qam
command is issued on a particular QAM interface.
Conditions: This issue occurs when the
default interface range qam
command
is issued on a particular QAM interface.
Workaround: Do not use the
default interface range qam
command.
CSCud38529
Symptoms: Data plane DEPI sessions go to idle state after a TCC card reset.
Conditions: This issue occurs after a TCC card reset.
Workaround: Reset the Cisco RFGW-10 DS-48 line card.
CSCud39606
Symptoms: DEPI sessions go to idle state after QAM interfaces are in down state.
Conditions: This issue occurs after a Supervisor card switchover.
Workaround: There is no workaround.
CSCud43963
Symptoms: Downstream channel is in down state although the DEPI session
associated with the QAM interface is in up state, because the QAM mode for each
QAM interface is OFF.
Conditions: This issue occurs when remote DEPI learn mode is configured. This
issue occurs when frequency stacking is changed from 4 to 1 and TSID
configuration is removed.
Workaround: Reconfigure the DEPI configuration (TSID and DEPI tunnel) in
each QAM interface.
Caveat
Description