November 28, 2012 | Cisco Systems | PrecisionHD 4X Camera Connectivity Problems
19
SANGAM#saveenv
Power cycle the camera. USB access is now disabled, so the VISCA serial connection is now active.
Verify using serial access that the camera boots to linux properly. You should no longer see any checksum errors;
you should see the camera go straight to "Booting Linux..." as in the below example:
DM365 chip initialization done
Board id : 00000001 Version id : 00000006
version 5
Configuring FPGA
Done
boot_delay : 3
boot_delay : 2
boot_delay : 1
boot_delay : 0
Booting Linux.....
Once successful camera boot is verified, connect the camera with its newly programmed software to the C-series
codec. Verify the camera is successfully connected using "xstatus camera 1" and that it shows a firmware ID of
20011 or higher.
