4-27
PA-POS-2OC3 Two-Port Packet-over-SONET Port Adapter Installation and Configuration
OL-3028-06
Chapter 4 Configuring the PA-POS-2OC3
Checking the Configuration
Keepalive set (10 sec)
Scramble disabled
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (0 IP multicast)
0 runts, 0 giants, 0 throttles
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 applique, 1 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
Cisco 7401ASR Router—Example Output of the show interfaces Command
Following is an example of the
show interfaces pos
command for a PA-POS-2OC3 in port adapter slot
1 of a Cisco 7401ASR router:
Router#
show interfaces pos 1/0
POS1/0 is administratively down, line protocol is down
Hardware is Packet over Sonet
MTU 4470 bytes, BW 155000 Kbit, DLY 100 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of “show interface” counters never
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants
0 parity
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
10 packets output, 234 bytes, 0 underruns
0 output errors, 0 applique, 0 interface resets
0 output buffers copied, 0 interrupts, 0 failures
0 carrier transitions
VIP in Cisco 7500 Series Routers—Example Output of the show interfaces Command
Following is an example of the
show interfaces pos
command used with the VIP. In this example, the
two serial interfaces (0 to 1) are on a port adapter in port adapter slot 1 of a VIP in interface processor
slot 1. Most of the status information for each interface is omitted. (Interfaces are administratively shut
down until you enable them.)
Router#
show interface pos 1/0/1
POS1/0/1 is up, line protocol is up
Hardware is cyBus Packet Over Sonet
Internet address is 11.0.0.1/16
MTU 4470 bytes, BW 155000 Kbit, DLY 100 usec,
reliability 240/255, txload 4/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
