4-22
PA-POS-2OC3 Two-Port Packet-over-SONET Port Adapter Installation and Configuration
OL-3028-06
Chapter 4 Configuring the PA-POS-2OC3
Checking the Configuration
Cisco 7600 Series Routers with FlexWAN and Enhanced FlexWAN—Example Output of the show diag Command
Following is an example of the
show diag
command that shows a PA-POS-2OC3 in bay 1 in a FlexWAN
module:
Router#
show diag
Slot 6: Logical_index 17
FlexWAN controller
Board is analyzed ipc ready
HW rev 1.4, board revision D0
Serial Number: SAD053706A5 Part number: 73-3869-07
Slot database information:
Flags: 0x2004 Insertion time: 0x1CCC8 (2w6d ago)
Controller Memory Size:
112 MBytes CPU Memory
16 MBytes Packet Memory
128 MBytes Total on Board SDRAM
IOS (tm) cwlc Software (cwpa-DW-M), Version 12.2(17d)SXB1,
RELEASE SOFTWARE (fc2)
PA Bay 1 Information:
POS PA, 2 port, PA-POSSW-MM
EEPROM format version 1
HW rev 2.02, Board revision A0
Serial number: 29xxxxxx Part number: 73-xxxx-xx
Using the show interfaces Command
Display status information (including the physical slot and interface address) for the interfaces you
specify using the
show interfaces
command.
For complete descriptions of interface subcommands and the configuration options available for the
individual platforms, refer to the publications listed in the
“Related Documentation” section on page iv
.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
The following sections provide platform-specific output examples using the
show interfaces
command:
•
Cisco 7200 VXR Routers—Example Output of the show interfaces Command, page 4-23
•
Cisco 7201 Router—Example Output of the show interfaces Command, page 4-23
•
Cisco 7301 Router—Example Output of the show interfaces Command, page 4-24
•
Cisco 7304 Router—Example Output of the show interfaces Command, page 4-26
•
Cisco 7401ASR Router—Example Output of the show interfaces Command, page 4-27
•
VIP in Cisco 7500 Series Routers—Example Output of the show interfaces Command, page 4-27
•
