9-6
Cisco ONS 15600 SDH Reference Manual, Release 9.0
78-18400-01
Chapter 9 Management Network Connectivity
9.2.5 Scenario 5: Using Static Routes to Connect to LANs
Figure 9-4
Scenario 4: Default Gateway on a CTC Computer
9.2.5 Scenario 5: Using Static Routes to Connect to LANs
Use static routes for the following two reasons:
•
To connect ONS 15600 SDHs to CTC sessions on one subnet connected by a router to
ONS 15600 SDHs residing on another subnet. (These static routes are not needed if OSPF is
enabled. Scenario 6 shows an OSPF example.)
•
To enable multiple CTC sessions among ONS 15600 SDHs residing on the same subnet.
In
, one CTC residing on subnet 192.168.1.0 connects to a router through interface A. (The
router is not set up with OSPF.) ONS 15600 SDHs residing on subnet 192.168.2.0 are connected through
Node 1 to the router through interface B. To connect to CTC computers on LAN A, you would create a
static route on Node 1.
CTC Workstation
IP Address 192.168.1.100
Subnet Mask at CTC Workstation 255.255.255.0
Default Gateway = 192.168.1.10
Host Routes = N/A
ONS 15600 SDH #2
IP Address 192.168.2.20
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes = N/A
ONS 15600 SDH #1
IP Address 192.168.1.10
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes = N/A
ONS 15600 SDH #3
IP Address 192.168.3.30
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes = N/A
LAN A
SDH RING
159614
