165
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter F Commands
feature-set virtualization
feature-set virtualization
To enable the Cisco Virtual Machine features on the switch, use the
feature-set virtualization
command. To disable the virtualization feature, use the
no
form of this command.
feature-set virtualization
no feature-set virtualization
Syntax Description
This command has no arguments or keywords.
Command Default
None
Command Modes
Global configuration mode
Command History
Usage Guidelines
Note
The Cisco virtual machine feature is supported only on the Cisco Nexus devices.
Before you use this command, make sure that you install the virtualization feature set on the switch by
using the
install feature-set virtualization
command.
You cannot view or access any virtualization commands until you enable a Cisco virtual machine on the
switch.
Note
You must install the Cisco virtual machine feature set before you enable virtualization on the switch.
Before you disable this feature on the switch, do the following:
•
Remove all virtual Ethernet interface configurations on the switch.
•
Remove all virtual network tag (VNTag) configurations on the switch.
•
Remove all port profiles of type vethernet.
•
Change the port mode to access by using the
switchport mode access
command.
This command requires an Enhanced Layer 2 license.
Examples
This example shows how to enable the virtualization feature on the switch:
switch#
configure terminal
switch(config)#
feature-set virtualization
Release
Modification
5.2(1)N1(1)
This command was introduced.
