1318
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter Show Commands
show lacp
show lacp
To display Link Aggregation Control Protocol (LACP) information, use the
show lacp
command.
show lacp
{
counters
|
interface ethernet
slot/[QSFP-module/]port
|
neighbor
[
interface
port-channel
number
] |
port-channel
[
interface port-channel
number
] |
system-identifier
}
Syntax Description
Command Default
None
Command Modes
EXEC mode
Command History
Usage Guidelines
Use the
show lacp
command to troubleshoot problems related to LACP in a network.
Examples
This example shows how to display the LACP system identification:
switch#
show lacp system-identifier
32768,0-5-9b-78-6e-7c
switch#
This example shows how to display the LACP information for a specific interface:
switch#
show lacp interface ethernet 1/1
Interface Ethernet1/1 is up
Channel group is 1 port channel is Po1
PDUs sent: 1684
PDUs rcvd: 1651
Markers sent: 0
counters
Displays information about the LACP traffic statistics.
interface ethernet
slot/[QSFP-module/]port
Displays LACP information for a specific Ethernet interface. The
slot
number is from 1 to 255. The
QSFP-module
number is from 1 to 4. The
port
number is from 1 to 128.
Note
The
QSFP-module
number applies only to the QSFP+ Generic
Expansion Module (GEM).
neighbor
Displays information about the LACP neighbor.
port-channel
Displays information about all EtherChannels.
interface port-channel
number
(Optional) Displays information about a specific EtherChannel. The
EtherChannel number is from 1 to 4096.
system-identifier
Displays the LACP system identification. It is a combination of the port
priority and the MAC address of the device.
Release
Modification
6.0(2)N1(1)
Support for the QSFP+ GEM was added.
5.2(1)N1(1)
This command was introduced.
