148
Cisco Nexus 5500 Series NX-OS Layer 2 Interfaces Command Reference
OL-27880-02
Chapter E Commands
errdisable recovery cause
errdisable recovery cause
To configure the application to bring the interface out of the error-disabled (err-disabled) state and retry
coming up, use the
errdisable recovery cause
command. To revert to the defaults, use the
no
form of
this command.
errdisable recovery cause
{
all
|
bpduguard
|
failed-port-state
|
link-flap-recovery
|
pause-rate-limit
|
udld
}
no errdisable recovery cause
{
all
|
bpduguard
|
failed-port-state
|
link-flap-recovery
|
pause-rate-limit
|
udld
}
Syntax Description
Command Default
None
Command Modes
Global configuration mode
Command History
Usage Guidelines
When error disable recovery is enabled, the interface automatically recovers from the err-disabled state,
and the device retries bringing the interface up.
Examples
This example shows how to enable error disable recovery from linkstate-flapping:
switch(config)#
errdisable recovery cause link-flap
switch(config)#
all
Enables a timer to recover from all causes.
bpduguard
Enables a timer to recover from bridge protocol data unit (BPDU) Guard
error disable state.
failed-port-state
Enables a timer to recover from a Spanning Tree Protocol (STP) set port
state failure.
link-flap
Enables a timer to recover from linkstate flapping.
pause-rate-limit
Enables a timer to recover from the pause rate limit error disabled state.
udld
Enables a timer to recover from the Unidirectional Link Detection (UDLD)
error disabled state.
Release
Modification
5.2(1)N1(1)
This command was introduced.