49
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
78-10406-05
Administering the NAM
Step 3
Enter the new password again:
Retype new UNIX password:
passwd: all authentication tokens updated successfully
This example shows how to set the password for the root account:
root@localhost#
password root
Changing password for user root
New UNIX password:
Retype new UNIX password:
passwd: all authentication tokens updated successfully
If you forget or lose the password, you can enter the
clear module password
command from the CLI to
restore the password for the root account to root and the guest account to guest.
To restore the NAM password to the factory-set defaults, enter this command in privileged mode:
Console> (enable)
clear module password
mod
Resetting the NAM
If you cannot reach the NAM through the CLI or an external Telnet session, enter the
reset
command to
reset and reboot the NAM. The reset process requires several minutes.
To reset the NAM from the CLI, perform this task in privileged mode:
This example shows how to reset the NAM, installed in slot 2, from the CLI:
Console> (enable)
reset 2
Module 2 shut down in progress, please don't remove module until shutdown completed
Resetting module 2....
2000 Feb 15 15:39:42 %SYS-5-MOD_OK:Module 2 is online
Console> (enable)
To reboot the NAM, perform this task while you are logged into the root account on the NAM:
This example shows how to reboot the NAM:
root@localhost#
reboot
Reboot the NAM? [Y/N]:
y
System reboot in progress..
Upgrading the NAM Software
You can upgrade both the application software and the maintenance software. To upgrade the application
software, see the
“Upgrading the NAM Application Software” section on page 50
. To upgrade the
maintenance software, see the
“Upgrading the NAM Maintenance Software” section on page 51
.
Task
Command
Reset the NAM.
reset
NAM_mod
Task
Command
Reset the NAM.
reboot
