13
Catalyst 6000 Family Network Analysis Module Installation and Configuration Note
78-10406-05
Installing and Removing the NAM
Caution
Always use the ejector levers when installing or removing the NAM. A module that is partially seated
in the backplane will cause the system to halt and subsequently crash.
Step 8
Keep the NAM at a 90-degree orientation to the backplane (horizontal to the floor), and carefully slide
the module into the slot until the notches on both ejector levers engage the chassis sides.
Step 9
Using the thumb and forefinger of each hand, simultaneously pivot both ejector levers forward to fully
seat the module in the backplane connector. (See
Figure 4
.)
Note
If you perform a hot swap, the console displays the message “Module
n
has been inserted.”
If you are running Cisco IOS, the console displays the message “Power to Module in slot n
set on.” These messages do not appear when you are connected to the Catalyst 6000 family
switch through a Telnet session.
Figure 4
Ejector Levers and Captive Installation Screws
Step 10
Use a screwdriver to tighten the captive installation screws on the left and right sides of the NAM.
Note
After you install or reinstall the NAM into a switch, you must log in to the NAM root account and
configure the NAM parameters before you can use the NAM for network analysis. See the
“Initial
Configuration” section on page 24
for instructions on how to configure the NAM parameters.
STATUS
PCMCIA
SLOT
1
0
EJECT
33088
Captive
installation
screws
Ejector lever
NTWK ANALYSIS HDL
MD
SHUTDOWN
For Vendor Use Only
WS-X6380-NAM
