1-12
Cisco Network Convergence System 6000 Series Routers Unpacking, Moving, and Securing Guide
OL-29233-01
Chapter 1
Dolly Specifications
Figure 1-7
Chassis Dolly—Removing Holding Bolts and Swinging Arm Out to 180-Degrees
Step 6
Swing the lift arm swing bracket to the side (180-degree position as shown in
Figure 1-7
). Reinsert the
holding bolts and partially tighten the bolts.
Step 7
Repeat Step 1 through Step 6 for the other dolly unit.
Figure 1-6
shows the dolly in a 180-degree
configuration.
Step 8
Lock the dolly caster brakes and anti-rotation pins until you are ready to move the chassis.
Step 9
Using the 3/8-inch ratchet wrench with 12-mm hex bit, firmly tighten the holding bolts on both dolly
units.
Note
To change the configuration back to the 90-degree configuration, repeat these steps and swing
the arm into the 90-degree position.
209076
