4-2
Administrator’s Guide for Cisco MeetingPlace Video Integration Release 5.3
OL-6280-01
Chapter 4 Configuring and Managing Cisco MeetingPlace Video Integration
About Changing System Configuration Settings
Users of ISDN video endpoints dial in using an ordinary E.164 number, wait for an IVR prompt, then
enter the code for the conference they want to attend.
About Changing System Configuration Settings
Cisco MeetingPlace Video Integration components are configured to work together. Settings in each
component enable communication between the components. If you change settings in one component,
you must also change the corresponding setting you entered in other components.
Table 4-1
Video Conferencing Access Information
Parameter Values
Where
Specified
Video Service Code
The service prefix that is assigned
to the dedicated MeetingPlace
service created on the
Cisco IPVC MCU.
The Video Service Code in
MeetingTime must match the
MeetingPlace service prefix
defined on the Cisco IPVC MCU.
You specified the service prefix when
you installed
Cisco MeetingPlace Video Integration
.
To view the service prefix:
In MeetingTime, click the
Configure
tab, look for the
COMPANY
SPECIFIC INFORMATION
heading, click U
sage Parameters
,
then scroll down in the panel on the
right to the
Video Service Code
field.
This value will be updated
automatically in MeetingTime if you
change it on the Cisco IPVC MCU. It
is best not to make changes after
meetings are scheduled.
Main video phone
number
If your Cisco IPVC MCU system
is configured to support ISDN
video endpoints, enter the
telephone number those endpoints
used to dial in to the
Cisco IPVC MCU. This is the DID
number assigned to the Cisco
IPVC PRI Gateway associated
with your Cisco IPVC MCU.
For information, see the
documentation for your Cisco
IPVC PRI Gateway.
In MeetingTime, click the
Configure
tab, look for the
SYSTEM
CONFIGRATION
heading, click
Telephony Access
, then scroll down in
the panel to the right to the
Video
Information
section.
1st alternate video phone
number
2nd alternate video
phone number
Cisco MeetingPlace does not
currently use these fields.
In MeetingTime, click the
Configure
tab, look for the
SYSTEM
CONFIGRATION
heading, click
Telephony Access
, then scroll down in
the panel to the right to the
Video
Information
section.