A-6
Cisco H.323 Signaling Interface User Guide
OL-4806-01 Rev. A14
Appendix A MML User Interface and Command Reference
MML Help
Error Messages
If an MML command does not perform, an error message is displayed.
Table A-4
lists the MML error
messages and their descriptions.
.
MML Help
MML has an online help feature. The MML
help
command displays a list of valid system commands
and an explanation of each command’s use. To display the online help, start an MML session and type
help
at the command line prompt. See the
“help” section on page A-11
.
Quitting an MML Session
To quit an MML session, type
quit
at the prompt.
Table A-4
MML Error Messages and Descriptions
Error Message
Definition
Description
DENY
Command denied
The system recognizes the command but does not
perform the requested function.
ICNV
Input command not valid
The system does not recognize the MML
command.
IDNV
Input data not valid
An unknown parameter was entered.
IISP
Input syntax error
Incorrect syntax was entered.
IITA
Invalid target
The system cannot perform the requested
operation on the specified component, or the
component does not exist.
IPRM
Input parameter missing
An expected parameter was not entered.
SABT
Status abort
The requested operation did not complete within
the allotted time.
SNVS
Component not in valid state The requested operation failed because the
component is either not configured to accept the
operation or the component is already in the
desired state.
SNSP
State not supported
The operation is not supported by the component.
SROF
Status requested operation
failed
The requested operation failed.