3-15
Installation Guide for Cisco Secure ACS Solution Engine 4.1
OL-9969-03
Chapter 3 Installing and Configuring Cisco Secure ACS Solution Engine 4.1
Initial Configuration
h.
If network connectivity is validated in the previous two steps, at the prompt,
Test network
connectivity [Yes]:
, type
n
or
N
, and then press
Enter
.
Tip
The system continues to provide you with the opportunity to test network connectivity until you
answer
no
. This means that you can correct network connections or retype the IP address.
Step 16
If the settings appear correctly, at the prompt,
Accept network setting [Yes]:
, type y or
Y
, and then
press
Enter
.
Result
:
The system displays the following message on the console:
Current Date Time Setting:
Time Zone: (GMT -xx:xx) XXX Time
Date and Time: mm/dd/yyyy
NTP Server(s): NTP Synchronization Disabled.
Step 17
To set the time and date of the ACS SE, at the
Change Date & Time Setting [N]:
prompt, type
Y
, and
then press
Enter
.
Result
:
The system displays a numbered list of time zones.
Step 18
At the
Enter desired time zone index (0 for more choices):
prompt, type the index number of
the time zone that you want, and then press
Enter
.
Result
:
The system displays the new time zone.
Step 19
At the
Synchronize with NTP server? [N]:
prompt, do one of the following:
•
To set the time manually, type
N
, and then press
Enter
.
•
To use an NTP server for setting time, type
Y
, and when prompted enter the IP address of the NTP
server that you want.
Tip
Only if you select to use an NTP server can you subsequently use the
ntpsync
command.
Result
:
The system displays a confirmation message reflecting your choice
.
Step 20
At the
Enter date [mm/dd/yyyy]:
prompt, type the date in the given format, and then press
Enter
.
Step 21
At the
Enter time [hh:mm:ss]:
prompt, type the current time in the given format, and then press
Enter
.
Result
:
The system displays the following message on the console:
Initial configuration is successful
.
Appliance will now reboot.
The system reboots.
Verifying the Initial Configuration
To verify that you have correctly completed the ACS SE initial configuration:
Before You Begin
Establish a serial console connection to the ACS SE. For details, see
Establishing a Serial Console
Connection, page 3-10
.