Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up IOS Access Points
5-20
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
Configuring Infrastructure Access Points to Register with a Wireless LAN
Services Module (WSM)
To configure infrastructure access points to register with a Wireless LAN
Services Module, see the relevant AP and WSM documentation on Cisco.com.
Configuring Scanning APs
This section describes how to configure an AP as a scanning-only AP. After you
have performed the basic network management configuration and radio
management configuration described in this chapter, perform the additional
configuration described in this section to make the AP into a scanning AP.
Scanning APs can detect and report “bug-lighted” clients (clients associated to
unauthorized access points). Scanning APs do not accept client associations.
For more information on scanning APs and other requirements for using scanning
APs with a WLSE, see the online help “Radio Management” chapter in the
User
Guide for the CiscoWorks Wireless LAN Solution Engine, Release 2.7
.
Note
Radio scanning requires a read/write SNMP community string on APs. For more
information, see
Radio Management Setup—IOS Devices, page 5-10
,
Table 5-3 on page 5-20
lists the high level tasks for setting up scanning APs.
Table 5-3
Setting Up Scanning APs Quick Reference
Task
References
1.
Configure the scanning APs for basic
management and radio management.
•
Do not
configure VLAN/SSID on the
scanning AP.
•
Do not
configure the scanning AP as
a WDS device.
Setting Up IOS Access Points, page 5-4
2.
Configure the specific scanning AP
parameters.
Configuring a Scanning AP—Using the AP CLI,
page 5-21
Configuring a Scanning AP—Using a WLSE
Configuration Template, page 5-21
