Chapter 6 Cabling the Line Ports and Completing the Installation
Connecting the line ports to the network
SCE 2000 4xGBE Installation and Configuration Guide
OL-7824-02
6-11
E
XAMPLE
:
The following example displays a system response.
SCE 2000
#
show interface GigabitEthernet 0/1
Auto negotiation configured: Enabled
Actual Status:
Link is on
Auto negotiation: Enabled
Bandwidth: 100000Kbps
Burst-size: 50000bytes
Auto-negotiation for bump-in-the-wire topology may be enabled or disabled. For receive-only
topologies, using an external splitter, auto-negotiation must be disabled.
To view the Gigabit Ethernet counters, complete the following steps:
Step 1
At the
SCE 2000
# prompt, type
show interface GigabitEthernet 0/
interface-
number
counters
.
This displays the GigabitEthernet counters. This command enables you to verify that traffic is taking place.
You can see that the counters increase, together with the increased number of packets that flow through the
SCE 2000
.
Again, in bump-in-the-wire topology, both the Rx and Tx counters apply as traffic monitors. For receive-
only topologies, using an external splitter, only the Rx counters apply.
E
XAMPLE
:
The following example shows the counters of the first Gigabit Ethernet interface.
SCE 2000
#
show interface GigabitEthernet 0/1 counters
In total octets: 100
In good unicast packets: 90
In good multicast packets: 0
In good broadcast packets: 10
In packets discarded: 0
In packets with CRC/Alignment error: 0
In undersized packets: 0
In oversized packets: 0
Out total octets: 93*2^32+1022342538
Out unicast packets: 858086051
Out non unicast packets: 0
Out packets discarded: 0
You are now ready to continue to the next stage, loading and activating an SCE application.
