Purpose
Command or Action
Restarts the interface
no shutdown
Example:
Router(config-mon-rspan-dst)# no shutdown
Step 6
Exists the configuration
end
Example:
Router(config-mon-rspan-dst)# end
Step 7
Removing Sources or Destinations from a RSPAN Session
To remove sources or destinations from a RSPAN session:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
monitor session session_number
4.
no
{
source
|
destination}
{
single_interface slot/subslot/port
|
single_vlan
} [
,
|
- both
|
rx
|
tx
]
5.
end
DETAILED STEPS
Purpose
Command or Action
Enables privileged EXEC mode.
enable
Step 1
Example:
Router>
enable
•
Enter your password if prompted.
Enters global configuration mode.
configure terminal
Example:
Router#
configure terminal
Step 2
Configures an RSPAN source session number and enters RSPAN
source session configuration mode for the session.
monitor session session_number
Example:
Router(config)#
monitor session 1
Step 3
•
session_number
—
The valid sessions are 1 through 14.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
394
Configuring Switched Port Analyzer
Removing Sources or Destinations from a RSPAN Session
