Purpose
Command or Action
Returns to global configuration mode.
exit
Example:
Device(config-if)# exit
Step 20
Specifies an interface.
interface type number
Example:
Step 21
Configures an Ethernet service instance on an interface
and enters Ethernet service configuration mode.
service instance id ethernet
[
evc-name
]
Example:
Device(config-if)# service instance 333 ethernet
evc1
Step 22
Sets the encapsulation method used by the interface.
encapsulation encapsulation-type
Example:
Device(config-if-srv)# encapsulation dot1q 5
Step 23
Binds a service instance to a bridge domain instance.
bridge-domain bridge-id
Example:
Device(config-if-srv)# bridge-domain 100
Step 24
Configures the MEP domain and the ID.
cfm mep domain domain-name mpid id
Example:
Device(config-if-srv)# cfm mep domain L4 mpid
4001
Step 25
Returns to privileged EXEC mode.
end
Example:
Device(config-if-srv)# end
Step 26
Configuring and Enabling the Cross-Check Function
Configuring and Enabling Cross-Checking for an Inward Facing MEP on the U PE-A
Perform this task to configure and enable cross-checking for an inward facing MEP. This task requires you
to configure and enable cross-checking on two devices. This task is optional.
Carrier Ethernet Configuration Guide (Cisco ASR 920 Series)
190
Configuring Ethernet Connectivity Fault Management in a Service Provider Network
Configuring Ethernet CFM
