2-15
Cisco TelePresence System
OL-16441-01
Chapter 2 Options for the Cisco TelePresence System 500-37
Cisco TelePresence Presentation Codec
Adding a Cisco TelePresence Presentation Codec with a Auxiliary Control Unit
To add a presentation codec to an CTS 500 with an auxiliary control unit, complete the steps in the
“Adding a Presentation Codec” section on page 2-5
and perform the following additional cabling steps:
•
Connect the Primary Codec Document Camera Ethernet connection (orange Ethernet connection on
the primary codec) to one Ethernet port of the auxiliary control unit.
•
Connect the other Ethernet port of the auxiliary control unit to the Presentation Codec Ethernet port
(white/red Ethernet connection on the presentation codec).
Note
The Ethernet ports in the auxiliary control unit are interchangeable. Use either of the ports for the
connections from the primary codec and the presentation codec.
Configuring a Cisco TelePresence Presentation Codec
To configure the presentation codec with the CTS 500, complete the following steps.
Step 1
Log in to the Cisco Unified Communications Manager web GUI.
Step 2
Navigate to
Device > Phone
.
Step 3
Find the Cisco Unified IP Phone that controls your Cisco TelePresence system by clicking
Find
.
Step 4
Click the hypertext link next to the phone that controls your Cisco TelePresence System to select it.
Step 5
In the Optional Hardware area, click the
Presentation Codec
check box.
Figure 2-12
Presentation Codec Check Box
Note
The options that display in this area might differ from what you see in your system.
Step 6
Click
Save
, then, click
Apply Config
to apply the configuration to your system.
