6-96
Cisco TelePresence System
OL-16441-01
Chapter 6 Options for the Cisco TelePresence System 3000, 3010, 3200, and 3210
Upgrading a CTS 3000 to a CTS 3200
Powering On the System
To power on the system, complete the following steps.
Step 1
Reconfigure the codec for the new MAC address in Cisco Unified Communications Manger by
performing the following actions:
a.
Open a browser on a computer connected to the network.
b.
Access the Cisco Unified Communications Manager interface.
c.
Find the current phone profile for the system, making a note of the settings.
d.
Delete the current phone profile.
e.
Create a new profile, making the following changes:
•
Use the phone type of
Cisco TelePresence 3200
.
•
If you replaced the primary codec, use the MAC address of the new codec in the phone profile.
For more information, refer to the
“Adding a Cisco TelePresence Device to the Unified CM Server”
section of the
Cisco Unified Communications Manager Configuration Guide for the Cisco
.
Step 2
Power on the system by turning the power switches to the On position on the two left PDUs, single right
PDU, and auxiliary control unit.
Six check boxes display on the lower right corner of the center display screen.
Step 3
Wait while the system checks each check box and clears the screen.
The system IP address displays on the lower right corner of the center display screen.
Step 4
Write down the IP address. This is the address of the primary codec.
Step 5
In the computer browser, type in the IP address of the primary codec unit.
Step 6
Enter the required information at the login screen. The Cisco TelePresence Administrator window
appears.
Step 7
Verify the status of the Cisco Unified Communications Manager (seen in the lower left portion of the
window) is
Enabled/Up
.
Step 8
Select
Hardware Setup
to verify the cameras, displays, speakers, and microphones are working
properly.
Step 9
Navigate to the
Device Information > Configuration > CUCM settings
window, then perform the
following actions:
a.
In the Certificate Trust List (CTL) area, delete the CTL from your system by clicking
Delete CTL
.
b.
In the Use Configuration TFTP Server area, click
Automatic
to set TFTP conditions to their default
value and remove any alternate TFTP servers.
